Change Car Rear Silencer Honda Civic Aerodeck

Change Car Rear Silencer

Easy 0h45–1h30 ~75–150€
Temps estimé 0h45–1h30
Coût estimé ~75–150€
Difficulté Easy
Motorisations
Civic Aerodeck VI 1995-2001 5
  • 1.5i 16V VE Gas (D15Z3)
  • 1.6 16V VTi Gas (B16A2)
  • 1.6i 16V ES Gas (D16Y5)
  • 1.6i 16V LS Gas (D16Y7)
  • 1.6i 16V SR Gas (D16Y8)
Repair the silencer* 1h30
Repair the front silencer* 1h30
Align the front silencer* 0h30
Remove/refit the main silencer 0h30–1h30
Renew the main silencer 0h45–1h30
Repair the main silencer 0h30–0h45
Align the main silencer 0h30–0h30
Difficult main silencer removal* 0h30
Remove/refit the rear silencer 0h45–1h00
Renew the rear silencer 0h45–1h00
Repair the rear silencer 0h30–0h45
Weld a sheet-metal repair panel onto the rear silencer* 0h30
Difficult rear silencer removal 0h30–0h30
Remove/refit the rear silencer trim 0h30–0h30
Renew the rear silencer trim 0h30–0h30
Remove/refit the silencer 0h45
Renew the silencer 0h45
Repair the front silencer 0h45
Align the front silencer 0h30
Remove/refit the exhaust pipe bracket 0h30
Renew the exhaust pipe bracket 0h30

What is a Honda Civic Aerodeck rear silencer?

The rear silencer (also called the back box or rear muffler) reduces exhaust noise to an acceptable level. It is located at the end of the exhaust line, after the catalytic converter, particulate filter (if fitted), and sometimes an intermediate silencer.

When should you change the Honda Civic Aerodeck rear silencer?

No periodic replacement interval is specified. Carry out regular visual inspections for corrosion, holes, and deteriorated mounting rubbers. Signs that replacement is needed: louder exhaust noise, rattling from loose baffles, visible rust holes, exhaust fumes entering the cabin, or failure at the MOT/roadworthiness test.

Is it difficult to change the Honda Civic Aerodeck rear silencer?

Difficulty level 2/5: technically easy but may require effort if bolts and clamps are rusted. Key steps: raise the vehicle, apply penetrating oil to clamp bolts, remove the clamp connecting the silencer to the intermediate pipe, remove the mounting rubber hangers, fit the new silencer with new gasket/clamp, reattach mounting rubbers, check for leaks with engine running.