Change Car Rear Silencer Cadillac SRX
Change Car Rear Silencer
| Time Estimate | 1h00–1h30 |
|---|---|
| Cost Estimate | ~100–150$ |
| Difficulty | Easy |
| Vehicles |
SRX 2004-2010 2
SRX 2010-2016 2
|
| Remove/refit the silencer | 1h00 |
| Renew the silencer | 1h00 |
| Repair the silencer* | 1h30 |
| Repair the front silencer* | 1h30 |
| Align the front silencer* | 0h30 |
| Repair the main silencer | 0h30 |
| Align the main silencer* | 0h30 |
| Difficult main silencer removal* | 0h30 |
| Repair the rear silencer | 0h30 |
| Weld a sheet-metal repair panel onto the rear silencer* | 0h45 |
| Difficult rear silencer removal* | 0h30 |
What is a Cadillac SRX rear silencer?
The rear silencer (also called the back box or rear muffler) reduces exhaust noise to an acceptable level. It is located at the end of the exhaust line, after the catalytic converter, particulate filter (if fitted), and sometimes an intermediate silencer.
When should you change the Cadillac SRX rear silencer?
No periodic replacement interval is specified. Carry out regular visual inspections for corrosion, holes, and deteriorated mounting rubbers. Signs that replacement is needed: louder exhaust noise, rattling from loose baffles, visible rust holes, exhaust fumes entering the cabin, or failure at the MOT/roadworthiness test.
Is it difficult to change the Cadillac SRX rear silencer?
Difficulty level 2/5: technically easy but may require effort if bolts and clamps are rusted. Key steps: raise the vehicle, apply penetrating oil to clamp bolts, remove the clamp connecting the silencer to the intermediate pipe, remove the mounting rubber hangers, fit the new silencer with new gasket/clamp, reattach mounting rubbers, check for leaks with engine running.
2 generations covered
| Generation | Years | Vehicles | Fuel |
|---|---|---|---|
| SRX 2004-2010 | 2004-2010 | 3.6 V6 Gas (LY7), 4.6 V8 Gas (LH2) | Gas |
| SRX 2010-2016 | 2010-2016 | 2.8 V6 Turbo Gas (LAU), 3.0 V6 Gas (LFW), 3.6 V6 Bioethanol (E85),Gas (LFX) | Bioethanol (E85), Gas |
