Change Car Particulate Filter (DPF) Mercedes-Benz Sprinter

Change Car Particulate Filter (DPF)

Easy 0h30 ~50€
Temps estimé 0h30
Coût estimé ~50€
Difficulté Easy
Check the catalytic converter 0h30
Check/top up the diesel particulate filter fuel additive 0h30
Check the diesel particulate filter saturation (using a diagnostic tool) 0h30
Renew the diesel particulate filter fuel additive reservoir 3h00
Remove/refit the diesel particulate filter fuel additive reservoir 2h00
Remove/refit the catalytic converter 2h30
Renew the catalytic converter 4h00
Remove/refit the diesel particulate filter 3h30
Remove/refit the diesel particulate filter fuel additive injector 0h45
Renew the diesel particulate filter 3h30
Renew the diesel particulate filter fuel additive injector 0h45
Prepare the catalytic converter heat shield for installation* 0h45
Remove/refit the AdBlue tank 2h00
Drain/refill the AdBlue tank 0h45
Renew the AdBlue tank 3h00
Remove/refit the front catalytic converter 1h30
Renew the front catalytic converter 1h30
Remove/refit the rear catalytic converter 1h30
Renew the rear catalytic converter 1h30
Remove/refit the catalytic converter outlet temperature sensor 0h45
Renew the catalytic converter outlet temperature sensor 0h45

What is a Mercedes-Benz Sprinter particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Mercedes-Benz Sprinter particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Mercedes-Benz Sprinter particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Mercedes-Benz Sprinter particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Mercedes-Benz Sprinter particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.