Change Car Handbrake Cable Jeep Cherokee

Change Car Handbrake Cable

Very easy 0h30 ~50€
Temps estimé 0h30
Coût estimé ~50€
Difficulté Very easy
Motorisations
Cherokee 1984-2001 2
  • 2.5 MPI, -LPG LPG,Gas (HX (EPE))
  • 4.0 MPI, -LPG LPG,Gas (MX (ERH))
Cherokee 2014-2023 5
  • 2.0 T-GDi Gas (EC1)
  • 2.4 Gas (ED6)
  • 2.4 Gas (ED8)
  • 3.2 V6 Gas (EHB)
  • 3.2 V6 Gas (EHK)
Check the parking brake* 0h30
Adjust the parking brake 0h30
Check the brake pedal travel 0h30
Check the parking brake shoes* 0h30
Remove/refit the front parking brake cable 0h45
Renew the front parking brake cable 0h45
Remove/refit the parking brake cable 1h00
Renew the parking brake cable 1h00
Check the parking brake cable 0h30
Repair the handbrake cable* 0h30
Lubricate the parking brake cable* 0h30
Remove/refit the parking brake lever 1h00
Renew the parking brake lever 1h00
Repair the parking brake lever 0h30
Clean the parking brake shoes* 0h30
Mechanical parking brake* 0h30
Difficult parking brake cable removal* 0h30
Check the parking brake cable* 0h30
Repair the parking brake lever* 0h30

What is the function of Jeep Cherokee handbrake cables?

The handbrake cables transmit the force exerted on the lever (or pedal) to the rear brakes. The handbrake (parking brake) immobilises the vehicle when parked, even on steep slopes. It also serves as an emergency brake in the event of main braking circuit failure.

Does my Jeep Cherokee have handbrake cables?

Some vehicles have a handbrake with a lever and cables (entry-level models and those over 5 years old). Other vehicles have an electric parking brake operated via a button. Vehicles with electric parking brakes do not have conventional handbrake cables.

When should you change the Jeep Cherokee handbrake cables?

Replace if: the handbrake lever travel is excessive despite adjustment, the cable is frayed or corroded, the cable outer sheath is split, or the cable has seized (common in vehicles not driven regularly). Also replace if the vehicle rolls on a slope with the handbrake fully applied.

Is it difficult to change Jeep Cherokee handbrake cables?

Difficulty level 1/5: very easy. Key steps: release the handbrake, raise and support the vehicle, disconnect the cable from the brake mechanism at the wheel end, disconnect from the handbrake lever, feed the new cable through the same route, reconnect at both ends, adjust tension so the lever locks at 4–7 clicks, test on a slope.

Voir tous les produits compatibles →

2 générations couvertes

Génération Période Motorisations Carburant
Cherokee 1984-2001 1984-2001 2.5 MPI, -LPG LPG,Gas (HX (EPE)), 4.0 MPI, -LPG LPG,Gas (MX (ERH)) Gas, LPG
Cherokee 2014-2023 2014-2023 2.0 T-GDi Gas (EC1), 2.4 Gas (ED6), 2.4 Gas (ED8), 2.4 Gas (EDE), 3.2 V6 Gas (EHB), 3.2 V6 Gas (EHK) Gas

Nos autres guides de réparation

Change Car Accessory Belt Kit

Easy 0h45

Change Car Air Filter

Very easy 0h30–0h30

Change Car Battery

Very easy 0h30

Change Car Cabin Filter

Very easy 0h30–0h30

Change Car Clutch

Technical 6h00

Change Car Front Brake Discs and Pads

Easy 1h30

Change Car Front Brake Pads

Easy 1h00–1h30

Change Car Fuel Filter

Easy 0h30

Change Car Oil Filter

Easy 0h30

Change Car Rear Silencer

Easy 0h30–1h30

Change Car Shock Absorbers

Easy 0h45

Change Car Spark Plugs

Easy 0h30–1h30

Change Car Water Pump

Easy 2h00–5h00