Change Car Front Brake Discs and Pads Ford Probe

Change Car Front Brake Discs and Pads

Easy 1h30 ~150$
Time Estimate 1h30
Cost Estimate ~150$
Difficulty Easy
Vehicles
Probe 1993-1998 2
  • 2.0 16V Gas (FS-DE)
  • 2.5 V6 Gas (KL-DE)
Renew both front brake discs 1h30
Renew both rear brake discs 1h30

What is the role of brake discs and pads on a Ford Probe?

When you press the brake pedal, hydraulic pressure pushes the brake caliper pistons, which press the brake pads against the rotating discs. Through friction, kinetic energy is converted into heat, slowing the vehicle.

When should you change the Ford Probe front brake discs?

Brake discs should be measured with a micrometer; if below minimum thickness stamped on the disc, replacement is mandatory. Discs typically last 60,000–80,000 km. Always replace discs in pairs.

Why change discs and pads together on the Ford Probe?

It is strongly recommended to change discs and pads together to ensure optimal braking performance. New pads on worn discs will not bed in properly, leading to reduced braking efficiency, noise, and uneven wear.

Is it difficult to change Ford Probe front brake discs and pads?

Difficulty level 2/5: technically easy. Key steps: raise the vehicle, remove the wheel, unbolt the caliper and bracket, slide off the old disc, clean the hub face, fit the new disc, refit the bracket and caliper with new pads. Pump the brake pedal before driving.

2 generations covered

Generation Years Vehicles Fuel
Probe 1988-1992 1988-1992 2.2 Gas (LC22), 2.2 Turbo Gas (LC22T), 3.0 Gas (U30) Gas
Probe 1993-1998 1993-1998 2.0 16V Gas (FS-DE), 2.5 V6 Gas (KL-DE) Gas