Change Car Particulate Filter (DPF) Volkswagen Transporter

Change Car Particulate Filter (DPF)

Easy 0h30 ~50€
Temps estimé 0h30
Coût estimé ~50€
Difficulté Easy
Motorisations
Transporter T3 1980-1998 1
  • 1.6 D Diesel (CS)
Check the catalytic converter 0h30
Check the diesel particulate filter 0h30
Check the diesel particulate filter saturation (using a diagnostic tool) 0h30
Prepare the catalytic converter heat shield for installation* 0h45

What is a Volkswagen Transporter particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Volkswagen Transporter particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Volkswagen Transporter particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Volkswagen Transporter particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Volkswagen Transporter particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.

Voir tous les produits compatibles →
Consultez le carnet d'entretien de votre Transporter →

2 générations couvertes

Génération Période Motorisations Carburant
Transporter T2 1967-1979 1967-1979 1.6 Gas (AD), 1.6 Gas (AE), 1.6 Gas (AF), 1.6 Gas (AS), 1.6 Gas (B), 1.6 Gas (C), 1.7 Gas (CA), 1.7 Gas (CB), 1.7 Gas (CD), 1.7 Gas (CE), 1.7 Gas (EA), 1.8 Gas (AN), 1.8 Gas (AP), 1.8 Gas (AT), 1.8 Gas (AW), 1.8 Gas (ED), 2.0 Gas (CJ), 2.0 Gas (GD), 2.0 Gas (GE) Gas
Transporter T3 1980-1998 1980-1998 1.6 D Diesel (CS), 1.9 i Gas (DH), 2.0 Gas (CV), 2.1 i Gas (MV) Diesel, Gas

Nos autres guides de réparation

Change Car Accessory Belt Kit

Easy 0h30

Change Car Air Filter

Very easy 0h30

Change Car Battery

Very easy 0h30–0h30

Change Car Cabin Filter

Very easy 0h45

Change Car Clutch

Technical 3h30

Change Car Front Brake Discs and Pads

Easy 2h00

Change Car Front Brake Pads

Easy 1h30

Change Car Fuel Filter

Easy 0h30

Change Car Glow Plugs

Intermediate 2h00

Change Car Handbrake Cable

Very easy 0h30

Change Car Oil Filter

Easy 0h30

Change Car Rear Silencer

Easy 0h30–1h30

Change Car Shock Absorbers

Easy 1h30–3h00

Change Car Spark Plugs

Easy 0h45

Change Car Timing Belt Kit

Very technical 4h00

Change Car Turbo

Very technical 3h30

Change Car Water Pump

Easy 2h30
Consultez le carnet d'entretien de votre Transporter →