Change Car Particulate Filter (DPF) Mercedes-Benz 190
Change Car Particulate Filter (DPF)
| Temps estimé | 0h30 |
|---|---|
| Coût estimé | ~50€ |
| Difficulté | Easy |
| Motorisations |
190 1982-1993 2
|
| Check the catalytic converter | 0h30 |
| Remove/refit the catalytic converter (without oxygen sensors) | 2h00 |
| Renew the catalytic converter (without oxygen sensors) | 2h00 |
| Prepare the catalytic converter heat shield for installation* | 0h45 |
What is a Mercedes-Benz 190 particulate filter?
Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.
How does the Mercedes-Benz 190 particulate filter work?
As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.
When should you change the Mercedes-Benz 190 particulate filter?
The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.
Can the Mercedes-Benz 190 particulate filter be cleaned instead of replaced?
Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.
Is it difficult to change the Mercedes-Benz 190 particulate filter?
Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.
Produits pour ces véhicules
-
- Online
-
- Make Loading
- Model Loading
- Year Loading
- Sub-Model Loading
- Engine Loading
Loading compatibility information for your vehicle
-
Out of stock
-
- Make Loading
- Model Loading
- Year Loading
- Sub-Model Loading
- Engine Loading
Loading compatibility information for your vehicle
